Pronto 100% Pure Acetone. "The best product available for gel polish soak-off is anything with a high acetone concentration. This active ingredient easily breaks up the gel particles and quickly removes them without causing too much damage to the surface of the natural nails," says Totty. Allow the warm water to heat the acetone for about a minute, place your hand inside the acetone, and let the gels gradually soak off. You can also grab a ready-made product — like Red Carpet Step 4. Using an orange stick or metal polish remover tool, gently push the remaining loose gel off each nail. If the gel is not coming off easily DO NOT force, this is highly likely to take layers of nail with it and cause irreparable damage to the nail plate. Simply wrap in foil again (Step 3) and wait a further 5 minutes before trying again. 2.Apply a very thin layer of base gel, and cure it under UV/LED Lamp. 3.Apply extension nail gel on the tips mould. 4.Apply the gel on the root of the tips mould. 5.Press the extension nail gel with your fingers. 6.Put the tips mould with gel on your fingernails, and make sure it fully plying-up, then cure it under UV/LED Lamp. 7.Remove the LIFT. Lift the strip up gently from the side/edges. Using the wooden stick, apply nail polish remover drops between your nail and the strip. 1. Trim the Gel Slice as Much as Possible. Get rid of all excess gel, including the gel in front of or behind your DNA band. Most people cut out a square around the gel but don’t think to stand the excised piece up and trim the gel away from the front and back. If you pour a thick gel, there will be a lot more gel to remove. CIMNE. Dipping the part in liquid nitrogen, wrapping it in dry ice, or otherwise bringing its temperature below -60°C may embrittle an adhesive. Tapping of the cold part may shatter the bond and allow the parts to separate. Once separated, a solvent soak may still be necessary to remove residual material. Step 4: Remove the remaining paint. After soaking in acetone or remover, you may notice that the gel has started to break down. Use a cuticle pusher to push the remainder of the gel polish off the Twist the end of the foil and wrap it under your nail so it’s nice and tight. Do this to each nail until all of your gel nails are covered in soaked cotton balls and foil. Wrap the foil tightly around each nail so that the acetone won’t evaporate. 4. Wait for 10-15 minutes to let the acetone penetrate the gel. How to Remove UV Gel? 1.Soak nails in a glass bowl filled with a small amount of pure acetone,or wrap each nail in cotton pad soaked with pure acetone for around 5 to 10 minutes. 2.The product will start to become soft and you can gently file it away or slide it off using a small wooden stick. If you don’t want to soak your nails, you can also use foil, cotton and acetone to remove your gel extensions. Soak a cotton ball in acetone, attach it to the nail, and cover both with a piece of foil. Do this for each nail. Let the foils sit on your gel extensions for about 15 to 20 minutes. 3. 2.Apply a very thin layer of base gel, and cure it under UV/LED Lamp. 3.Apply extension nail gel on the tips mould. 4.Apply the gel on the root of the tips mould. 5.Press the extension nail gel with your fingers. 6.Put the tips mould with gel on your fingernails, and make sure it fully plying-up, then cure it under UV/LED Lamp. 7.Remove the

how to remove uv gel